Instructions for QuickScan:
*********************************
1.  Open files Groth4.pdf (these are volume 4 - highlight Groth400001.pdf
      through highest # file and hit select then open)
2.  Set IP  (IPmenu, configure)  Order matters!
     "halftone removal" --> add
     then highlight and hit configure
     uncheck "use region"
     add "rotation", configure --> counterclockwise
     add "crop", configure --> for odd pages: left - 7.5''
		          for even pages: left - 1.5''
			                 right- 6.5''
     click "ok" then go back to IP menu and click "enable during scan"
3.  Move cursor among pages to right of last
      go to "file" menu, scan batch to file, insert pages
4.  Align book on scanner with top facing left, LGL line
     on right side of scanner is the line-up point with text edge.
     Make sure left side of text lines is up wiht plastic/glass edge
     of scanner bed.
5.  Make sure "use flat bed" is checked and click "start scanning".
     Then, the number after "front of sheet" will change- this is the page
     you are scanning.   Double check this and click "continue scanning".
6.  When, however, pages of odd or even #'s that you want is done, 
      switch the crop configure and insert the odd or even pages between
      the others. 
      Click "stop scanning" before scanning the next insert or they'll be out
      of order.  (At "insert to current batch") screen, hit 'OK'.
7.  Pages can be replaced by placing the cursor to the left of the bad page
     and using "replace pages".  Remember "stop scanning" when done.

Note:  When starting new volume, choose naming schema.  The directions
for quickscan that are on reserve are very helpful.  Use the root Groth#
(where # is the volume followed by five digits- five # signs in schema)